CONTROL SOLUTIONS LogTag VFC400-USB Product User Manual page 14

Preparing a VFC400-USB for first use
The logger is unconfigured
An unconfigured VFC400-USB logger is delivered to you hibernated (i.e. in a state of low
power consumption), and pressing the
If your logger is unconfigured you must set it up with the parameters required for
starting and recording temperature values;
l
printing the PDF; and
l
triggering alarms.
l
This is done using Control Solutions VTMC software, which can also be used for
downloading and analyzing data:
Start the Control Solutions VTMC software.
l
Remove the protective cap from the logger's USB socket and plug the Micro USB
l
end of the cable into the socket. Plug the other end of the cable into a USB socket
on your computer and wait for the drivers to be installed.
From the menu click LogTag - Configure; Control Solutions VTMC will display the
l
configuration settings currently stored in your VFC400-USB for reviewing or
editing.
VFC400-USB User Guide
REVIEW
and then
button shows:
/MARK
14