Table of Contents
Advertisement
RUSKA 7750i
Users Manual
GPIB Address
Sets the IEEE-488 interface address.
Protocol
The Protocol defines which protocol should be used by the remote interface. The options are
Standard Communication for Programmable Instruments (SCPI) and RUSKA 6610 emulation.
Serial Interface Set-Up
The operator can set-up the Baud Rate, Data Bits, Parity, and Stop Bits for the Serial Interface.
Menu | Setup — System
The System Menu identifies the Software release version that is being operated in the ADTS.
It also stores and allows the operator to edit the Date and Time.
Date/Time
The ADTS's system clock is continuously updated. If the date or time requires editing, the
following applies;
1. The date and time are set from the Menu | Menu | Setup | System. From the Main Menu
(press PREVIOUS until the Main Menu appears), press Menu [F6], Menu [F6], then
Setup [F2], and then System [F5].
2. To set the system date, turn the rotary knob until Date is highlighted. Use the numeric keypad
to enter the current four-digit year, month, and day (yyyymmdd). All digits must be entered.
Press ENTER to accept.
3. To set the system time, turn the rotary knob until Time is highlighted. Use the numeric
keypad to enter the current hour, minute, and second (hhmmss). All digits must be entered.
Press ENTER to accept.
Reset
The Reset [F1] command is used to re-boot the ADTS.
To reset the system, from the Main Menu (press PREVIOUS until the Main Menu appears), press
Menu [F6], Menu [F6], then Setup [F2], then System [F5], and then Reset [F1].
4-16
Figure 4-15. Menu | Menu | Setup | System
gme22.bmp
Advertisement
Table of Contents
