Cross-Connections To Distribution Frames And Building - Northern Telecom DNC-50 Installation Manual

9. Cross-connections to Distribution
Frames and Building
Wiring cross-connections should be in place, having been installed by the
pre-installation wiring contracter prior to the installation of the system. However, if
the connections have not been made, or if updates are required, proceed according
to the instructions in this part.
This procedure describes how to make the basic connections to the building wiring.
Connections from the LIUs to other devices such as printers, modems, and host
computers are described in subsequent parts. For a record of the wiring connections
and port assignments, see the floor plan, wiring log, and provisioning tables in the
Site Records, 450-1011-152.
EQUIPMENT:
1
If the connectorized office cross-connect panel is not used, the connector should be
cut from the cable from the LANlink SRU. The wires can then be connected
individually to the distribution frame according to Table 9-A.
QTBIX16A connection tool.
87
Practice 450-1011-201