Northern Telecom DNC-50 Installation Manual page 90

(6) Route the cables down the left side of the cabinet, as viewed from the rear, and
out the space below the rear door. Tie-wrap the cable to the cabinet frame for
dressage.
(7) Route the cable along the floor at the rear of the cabinet, then to the office
cross-connect panel according to the floor plan.
Note: A cable rack should be used whenever possible. The rack should be
electrically isolated from the system ground.
(8) Connect the far end of each of the cables to one of the three Analog Link
connectors on the office cross-connect panel (Rows 1, 2 and 3). Row 1
corresponds to the top connector, Row 2 to the middle connector, and Row 3 to
the bottom connector. You may have to lift the retaining bar away from the
connectors before making the connections. (See Fig. 8-11 for details of the
internal cross-connections for analog lines in the cross-connect panel. Fig. 8-12
shows how to access those lines from an external trunk.)
(9) When the connectors are firmly seated, lower the retaining bar over them to
hold them in place.
Installing the Cross-Connect Panel 29
Practice 450-1011-201