Component Video Source With Tri Level Sync To Port 4/5 (Optional); Rs232 Connection; Communication Port For Communication With Peripherals - Barco BARCOREALITY 908 Installation Manual

6. Source Connections
RGB Analog Source with Tri Level Sync on Port 4/5 Selection
1. Press digit button 7 on the RCU.

6.8 Component Video Source with Tri Level Sync to Port 4/5 (Optional)

Which signal to Port 4/5?
Component video with tri level sync input can be connected to the projector via port 4/5. The projector detects automatically where
the sync signal is located. This feature requires a optional tri level sync module (Order number: R9828040).
Component Video Source with Tri Level Sync on Port 4/5 Selection
1. Press digit button 8 on the RCU.

6.9 RS232 Connection

RS232 Input and RS232 Output of the projector
The projector is equipped with a RS232 port that allows them to communicate with a computer.
• Easy adjustment of the projector via a computer.
• Allow storage of multiple projector configurations and set ups.
• Wide range of control possibilities.
• Address range from 0 to 255.
• Sending data to the projector or copying the data from the projector to a hard memory device.
Image 6-14
RS232 Connector
How to set up the baud rate for the communication with a computer?
See changing the baud rate in the chapter Service Mode of the Owner's Manual.

6.10 Communication Port for Communication With Peripherals

Connecting a RCVDS 05 switcher to the projector
• Up to 10 inputs (20 inputs when video and S-video) with the RCVDS 05 switcher (R9827880) and up to 90 inputs when 10
RCVDS switchers are linked via the 5-cable output modules.
• Serial communication with the projector.
• Remote control buttons on the RCVDS to control the projector (source selection and analog settings).
• The selected source number will be displayed on a 2 digit display and the selected input modules will be indicated with a LED
on the rear.
44 R5976354 BARCOREALITY 908 SPLIT PACK 10092002