Barco BARCOREALITY 908 Installation Manual page 46

6. Source Connections
Image 6-6
Second RGB Module
S1 Force Negative Sync (ON = Yes)
S2 Blue in Green (ON = Yes)
R1 Red
R21Green
R41Blue
R81Horizontal Sync.
R101 Vertical Sync.
When removing the second RGB module, turn off the projector and unplug the power cord from the wall outlet.
How to remove the second RGB module?
1. Loosen the two bolts on each side of the projector. (image 6-7)
2. Lift up the protection plate. (image 6-8)
3. The second RGB module is located in the slot 4 of the main frame. (image 6-9)
4. Press the module locks A and lift up the module handles B on both sides of the module. (image 6-10)
5. Disconnect the mini-connector J3 on the printed circuit board in slot 2, for easy handling, repeat step 4 to lift up this printed circuit
board. (image 6-11)
Note: When an optional Limo Plus is installed, the mini-connector is connected to the Limo Plus Print in slot 3.
6. Extract the second RGB module out of the main frame. (image 6-12)
7. When finished, reconnect mini-connector J3, secure the printed circuit boards and put back the protection plate.
Image 6-7
Loosen the two bolts on each side of the projector
40
Image 6-8
Lift up the protection plate
R5976354 BARCOREALITY 908 SPLIT PACK 10092002