Barco BARCOREALITY 908 Installation Manual page 39

This warm up period is built in so that the projector can reach its maximum specifications and minimize all
distortions.
When starting this warm up period, a full white image is shifted on the CRT faceplate to avoid a burn in. Every 30 seconds a text
box will be displayed on another place on the screen with the remaining time to go. The image dimensions can be adjusted with the
cursor keys to avoid scanning on the edges of the CRT's.
How to interrupt the warm up period?
1. Press EXIT on the RCU.
The warm up menu will be displayed with the remaining time indication.
2. Press EXIT again to quit the warm up cycle and to display the source.
Starting up in Stand By Mode
The projector starts up in stand by. Press a digit key corresponding to the desired source or press STBY key. The projector displays
the selected source or the warm up cycle message. When this warm up message appears on the screen, handle as described in
'Start up in Operational Mode'.
Do not display a stationary image with full brightness and contrast for longer than 20 min., otherwise you risk
damage to the CRT's.
How to switch off the projector?
1. Use the same power switch to switch off the projector.
R5976354 BARCOREALITY 908 SPLIT PACK 10092002
5. AC Power
33