Table of Contents
Advertisement
Always use an interface (e.g. Barco Magik Interface R9828120) when a computer and local monitor have to be
connected to the projector as the signal cable coming from the computer is limited to 60 cm due to interfer-
ences.
RGB Component Video Port 4/5 Selection
1. Press digit button 6 on the RCU.
6.5 RGB Analog Source with Tri Level Sync to Port 4/5 (Optional)
Which signal to Port 4/5?
RGB analog input terminals with tri level sync input or with tri level sync on green (BNC terminals). The projector detects automati-
cally where the sync signal is located. This feature requires a optional tri level sync module (Order number: R9828040).
RGB Analog Source with Tri Level Sync on Port 4/5 Selection
1. Press digit button 7 on the RCU.
6.6 Component Video Source with Tri Level Sync to Port 4/5 (Optional)
Which signal to Port 4/5?
Component video with tri level sync input can be connected to the projector via port 4/5. The projector detects automatically where
the sync signal is located. This feature requires a optional tri level sync module (Order number: R9828040).
Component Video Source with Tri Level Sync on Port 4/5 Selection
1. Press digit button 8 on the RCU.
6.7 RS232 Connection
RS232 Input and RS232 Output of the projector
The projector is equipped with a RS232 port that allows them to communicate with a computer.
•
Easy adjustment of the projector via a computer.
•
Allow storage of multiple projector configurations and set ups.
•
Wide range of control possibilities.
•
Address range from 0 to 255.
•
Sending data to the projector or copying the data from the projector to a hard memory device.
Image 6-11
RS232 Connector
How to set up the baud rate for the communication with a computer?
See changing the baud rate in the chapter Service Mode of the Owner's Manual.
R5976257 BARCO REALITY 909 15/03/2003
Computer
to computer
Port on projector
RS 232 OUT
RS 232 IN
6. Source Connections
33
Advertisement
Table of Contents
