Programming the NX-535N-V3 voice module
with a menu
Figure 2.
NX-535N-V3 menu structure
Recording
11.1
Playback
11.2
Handshake Digit
11.3
Kiss Off Digit
11.4
Model
11.5
Version
11.6
Reset Settings
11.7
You must enroll and default the NX-535N-V3 voice module before you begin to
program the system. To program the NX-535N-V3, select Installer Menu>NX-535
Voice Module.
Configuring the control panel for voice reporting
You must enable event reporting in the control panel and program the zones
types for which reports are sent. You must also map each event to a recorded
message. You can map one message to a number of events.
Events can be reported to three phone numbers. Each phone number has it own
account code, protocol and events. You must program this information for phone
number 1 at least. You can also set number of dial attempts and a dialer delay
for voice reporting.
Note:
All alarm reports will be cancelled and the voice module will stop dialing
when a valid user code is entered on a keypad.
NX-535N-V3 Voice Module Installation Manual
Leader Message
11.1.1
Single Event Message
11.1.3
11.1.5
Address Message
11.1.6
Kiss Off Message
Leader Message
11.2.1
Single Event Message
11.2.3
Address Message
11.2.5
Kiss Off Message
11.2.6
Message 1
11.1.3.1
Messages 2 - 15
Same as above
Message 1
11.2.3.1
Messages 2 - 15
Same as above
4
Need help?
Do you have a question about the Interlogix NX-535N-V3 and is the answer not in the manual?