Table of Contents
Advertisement
4. Press the button on the NX-535N-V3 module and record your message
through the handset. Example: "1420 North Main Street Gladewater, press
any key to continue"(*).
5. Press the button again to stop recording. Your message is automatically
played back.
Recording kiss-off message
1. Go to program mode of Voice module (Module 77).
2. Select Location 0.
•
Segment 1 = 1 (= record mode)
•
Segment 2 = 16 (= kiss-off message)
3. Connect a telephone handset into the RJ11 phone jack connector on NX-
535N-V3 module.
4. Press the button on the NX-535N-V3 module and record your message
through the handset. Example : "The Alarm message has been confirmed".
5. Press the button again to stop recording. Your message is automatically
played back.
(*) Only if Handshake and Kiss-Off are enabled on location 1.
Note:
The voice protocol can NOT generate a 'fail to communicate' signal.
Note:
All alarm reports will be cancelled and the voice module will stop dialling
when a valid user code is entered on a keypad.
Message table and lengths
The table below indicates the message types and the maximum length of each
individual message.
Message number
Leader Message
Event message #1
Event message #2
Event message #3
Event message #4
NX-535N-V3 Voice Module Installation Manual
Description
Start message played back until acknowledge by
means of DTMF code
Played back after acknowledgement of leader
message
Idem Event message #1
Idem Event message #1
Idem Event message #1
Max. duration
20 sec
8.5 sec
8.5 sec
8.5 sec
8.5 sec
11
Advertisement
Table of Contents
