Kernau KGH 6434 T CI B Instruction Manual page 34

4) FIXING THE HOT PLATE
INSTALLATION TYPE A:
The hot plate has a special seal which prevents liquid from infiltrating into the cabinet. Strictly comply with
the following instructions in order to correctly apply this seal:
- take off all the movable parts of the hob.
- Cut the seal in 4 parts of the necessary lenght to positionning it on the 4 edges of the crystal.
- Overturn the hot plate and correctly position seal "E" (fig. 11/A) under the edge of the hot plate itself, so
that the outer side of the seal perfectly matches the outer perimetral edge of the crystal. The ends of the
strips must fit together without overlapping.
- Evenly and securely fix the seal to the crystal, pressing it in place with the fingers.
- Place the hooks in their respective positions, use the hole no. 1 as reference for position lateral (fig. 9)
and hole no. 2 for positions rear (fig. 10).
- Secure hooks "G" by means of screws "F" (fig. 9/A for lateral, and fig. 10/A for rear).
- Insert the cooking hob in the hole of the kitchen cabinet by exercising a certain level of force in order to
get over the resistance of the hooks (fig. 9/B for lateral and fig. 10/B for rear). See the diagram on this
page.
- In order to avoid accidental touch with the overheating bottom of the hob, during the working, is
necessary to put a wooden insert, fixed by screws, at a minimum distance of 70 mm from the top (see
fig. 7).
Procedure for a correct installation of the hob
INSTALLATION
10