Regeneration Of Hotends In The Printing Module - 3DGence INDUSTRY F340 Maintenance Manual

Fig. 6 Offset calibration model for the Y axis
Calibration procedure for offsets in the X, Y axes:
1. Load the model and support filament by selecting from the printer menu Material Status → Load Filament
under the TOOL 0 and TOOL 1 extruder and follow the instructions on the display.
2. Print the calibration model stored in the printer memory by selecting Menu → Calibration → Printing Module
→ Automatic XY Calibration from the printer menu.
3. After printing the model, select the line on the display that best matches the model material with the support
material in part X.
4. Select the CONTINUE button.
5. Select the line on the display that best matches the model material with the support material in part Y.
6. Select the CONTINUE button.
7. Confirm by pressing the SAVE button.
8. Reprint the model stored in the printer memory by selecting Menu → Calibration → Printing Module →
Automatic XY Calibration from the printer menu and assess the calibration level of the offsets:
•
when the model material on the centre line (point 0.00) matches the support material both in the X axis
and in the Y axis, the offsets of the double-hotend module are calibrated correctly.
•
when the model material on the centre line (point 0.00) fails to match the support material both in the X
axis and in the Y axis, the offsets of the double-hotend module are not calibrated correctly. Recalibrate
the offsets according to steps 2 - 7.

6. REGENERATION OF HOTENDS IN THE PRINTING MODULE

Recommended frequency:
- in the event of hotend blockage or significant changes in quality noticed on the printed items.
The service life of the printing module hotend is at least 1000 hours of module service.
Print module lifetime is at least 4000 hours of module service or 1 year.
If there's a problem with the print hotends or the print module, contact the 3DGence technical support via the
request form at www.3dgence.com/support
3DGence INDUSTRY F340 - maintenance activities | version 04.2019
PART Y
(the form is available after you sign up and register your device).
page 8of 24