3DGence INDUSTRY F340 Maintenance Manual page 13

9. Slide the panel under two black spacers on one side of the printer and then bend the plate and slide it under
two black spacers on the other side (Fig. 16).
Fig. 16 Inserting the panel into the top cover
10. Place the top cover in the position as shown in the photo (Fig. 17).
Fig. 17 Placing the top cover
11. Use a sharp tool or a screwdriver to make a hole in the filter to screw the panel to the top cover (Fig. 18).
Fig. 18 Making holes in the filter
page 13of 24
3DGence INDUSTRY F340 - maintenance activities | version 04.2019