3DGence INDUSTRY F340 Maintenance Manual page 16

2. Select the right grease:
➢ for HIWIN ball screws and guide rails - HIWIN GREASE G01 (fig.25) or SKF LGEP 2 grease (Fig. 26).
Fig. 25 SKF LGEP 2 grease
➢ for SKF ball screws and guide rails - SKF LGEP 2 grease (Fig. 26) .
3. Fill the lubricator with the appropriate grease according to the manufacturer's instructions.
4. Lubricating the Z axis:
•
Set the heatbed to the lower position (Manual Controls → Down).
•
Lubricating linear guides:
- Push grease into the grease nipple of the left linear carriage (Fig. 27). It is located at the top of the liner
carriage. Push grease out by pressing the lubricator nozzle firmly against the grease nipple and pressing
smoothly the lubricator lever once.
Fig. 27 Lubricating the linear guides on the left side
- Repeat the operation for the right-hand carriage of the Z axis (Fig. 28).
Fig. 28 Lubricating the linear guides on the left side
3DGence INDUSTRY F340 - maintenance activities | version 04.2019
Fig. 26 SKF LGEP 2 grease
Grease nipple
Grease nipple
page 16of 24