3DGence INDUSTRY F340 Maintenance Manual page 21

Hide thumbs Also See for INDUSTRY F340:
Table of Contents

Advertisement

6. Position the carriage as shown in the picture (Fig. 38), viewing from the front of the printer:
Position the carriage on the X axis as shown in Fig. 39. The marked sheet metal edge should be positioned
in the middle of the fifth mounting hole of the linear guide, counting from the right side (Fig. 39).
The carriage on the Y axis shall be positioned as shown in Fig. 40. The marked sheet metal edge should be
positioned in the middle of the black mounting hole of the linear guide, counting from the fan on the rear
side of the printer (Fig. 40).
X2 axis
Fig. 38 Setting up the carriage
5
Fig. 39 Setting up the X axis carriage
3DGence INDUSTRY F340 - maintenance activities | version 04.2019
X1 axis
4
3
Y axis
2
1
Sheet metal edge
set in the middle of
the fifth black mounting hole of the
linear guide
page 21of 24

Advertisement

Table of Contents
loading

Table of Contents