Table of Contents
Advertisement
6. Pry the sheet metal panel with a screwdriver or other suitable tool (as shown in the picture) and slide the
sheet metal panel out from underneath the black housing spacers. The panel is flexible and can be bent (Fig.
13).
Fig. 13 Pulling the sheet metal panel from of the top cover
7. Put the sheet metal panel aside and remove the used filter (Fig. 14).
Fig. 14 Removing the used filter
8. Replace the old filter with a new one (Fig. 15).
Fig. 15 Inserting a new filter
3DGence INDUSTRY F340 - maintenance activities | version 04.2019
page 12of 24
Advertisement
Table of Contents
