3DGence INDUSTRY F340 Maintenance Manual page 18

•
Repeat the operation for the rear carriage of the X axis (Fig. 32).
Fig. 32 Lubricating the rear linear carriage of the X axis
•
Move the module to the right and left twice.
•
Remove excess grease from the linear carriages using a paper towel.
6. Lubricating the Y axis:
•
Move the module forward to the front of the printer until it stops to access the Y axis linear carriage
grease nipple (Fig. 33).
Fig. 33 Lubricating the Y axis
•
Push grease out by pressing the lubricator nozzle firmly against the grease nipple of the Y axis carriage
and pressing smoothly the lubricator lever once.
•
Move the module back and forth twice.
•
Remove excess grease from the linear carriages using a paper towel.
3DGence INDUSTRY F340 - maintenance activities | version 04.2019
Grease nipple
Grease nipple
page 18of 24