3DGence INDUSTRY F340 Maintenance Manual page 6

Fig. 3 Visualisation of the measurement by means of a calliper
MEASUREMENT: X:
100,08
100,06
100,05
100,04
100,05
AVERAGE: 100,05
Fig. 4 Heatbed of measurements for the X and Y axes
7. If the measurements are between 99.95 and 100.05 mm (tolerance of ±0.05 mm) and the difference between
the X and Y axes is between 0 and 0.05 mm, the printer is calibrated correctly.
8. If the printed item does not meet the above guidelines, an adjustment must be made:
•
From the printer menu, select Menu → Calibration → XY Calibration.
•
In the Original X box and using the +/- button, enter the original dimension for the X axis according to the
CAD design (100 mm in the X axis for the Dimmension_Calibration model downloaded from the
manufacturer's website).
If the compensation is for another model, enter a target value for a dimension in the X axis of the model
according to the CAD design.
•
In the Print X box enter the measured dimension for the X axis using the +/- button.
•
In the Original Y box and using the +/- button, enter the original dimension for the Y axis according to the
CAD design (100 mm in the Y axis for the Dimmension_Calibration model downloaded from the
manufacturer's website).
If the compensation is for another model, enter a target values for a dimension in the Y axis of the model
according to the CAD design.
•
In the Print Y box enter the measured dimension for the Y axis using the +/- button.
•
Save the measurements by selecting the SAVE command.
9. Restart the print job, then repeat these steps until the printer is calibrated and the dimensions are between
99.95 and 100.05mm (tolerance of ±0.05mm) and the difference between the dimensions is between 0 and
0.05mm.
With this procedure, the next item printed for which calibration has been carried out will be printed with the
material shrinkage compensation in the X and Y axes.
3DGence INDUSTRY F340 - maintenance activities | version 04.2019
Y:
100,07
100,06
100,08
100,06
100,05
100,06
page 6of 24