Replace The Air Filter On The Rear Side Of The Printer; Replace The Air Filter From The Top Side Of The Printer - 3DGence INDUSTRY F340 Maintenance Manual

9. REPLACE THE AIR FILTER ON THE REAR SIDE OF THE PRINTER

Recommended frequency:
The air filter on the back of the printer protects the user from harmful fumes and odours.
If you wish to replace it, please contact the 3DGence Technical Support to purchase a new filter.
Procedure for replacing the air filter on the rear side of the printer:
1. Turn the printer off and make sure you have access to the rear part of the printer.
2. Remove the filter housing by pulling it up (Fig. 8, step 1) and towards you (Fig. 8, step 2).
3. Remove the used air filter from the housing and insert a new one.
4. Replace the housing and the new filter on the printer following steps 1 and 2.
Fig. 8 Replacing the air filter

10. REPLACE THE AIR FILTER FROM THE TOP SIDE OF THE PRINTER

Recommended frequency:
If you wish to replace it, please contact the 3DGence Technical Support to purchase a new filter.
Procedure for replacing the air filter from the top side of the printer:
1. Turn the printer off and make sure you have good access to the top cover of the printer.
2. Remove the 4 DIN7991-M5x12 screws fixing the top cover to the printer and put them aside (Fig. 9).
Fig. 9 Unscrew the 4 DIN7991-M5x12 screws fixing the top cover to the printer.
3DGence INDUSTRY F340 - maintenance activities | version 04.2019
every six months or 2,000 hours of printer service.
every year the printer is in service.
page 10of 24