Table of Contents
Advertisement
AMD NVMe/SATA RAID Quick Start Guide for
Windows Operating Systems
3.3
Enable RAID for AMD SP3-Series Chipsets
Note: The steps to configure a system to RAID mentioned here are specific to AMD NDA BIOS
based off the AMI BIOS. The steps for other BIOS Vendors are different.
1. Power-on the system.
2. Press Delete or ESC to enter the System BIOS setup page.
3. In the BIOS setup:
a. Select the Advanced tab, then press Enter.
b. Select the AMD PBS tab, then press Enter.
c. Set NVMe RAID Mode to Enabled.
4. In the BIOS setup:
a.
Select the Advanced tab, then press Enter.
b. Select the AMD CBS tab, then press Enter.
c. Select FCH Common Options, then press Enter.
d. Select SATA Configuration Options, then press Enter.
e. Set SATA Controller to Enabled.
5. In the BIOS setup:
a. Select the Advanced tab, then press Enter.
b. Select the AMD CBS tab, then press Enter.
c. Select FCH Common Options, then press Enter.
d. Select SATA Configuration Options, then press Enter.
e. Set SATA Mode to RAID.
6. In the BIOS setup:
a. Select the Advanced tab, then press Enter.
b. Select Promontory Common Options, then press Enter.
c. Select PT SATA Configuration Options, then press Enter.
d. Set PT SATA Port Enable to Enabled.
7. In the BIOS setup:
a. Select the Advanced tab, then press Enter.
b. Select Promontory Common Options, then press Enter.
c. Select PT SATA Configuration Options, then press Enter.
d. Set PT SATA Mode to RAID.
8. In the BIOS setup:
a. Select the Advanced tab, then press Enter.
b. Select CSM Configuration, then press Enter.
c. Set CSM Support to Enabled.
d. Set Boot Option Filter to UEFI Only.
e. Set Storage to UEFI, then press Enter.
9. Save (F4) the setting and restart the system.
12
Pre-Installation Steps
56268 Rev. 1.05 November 2021
Chapter 3
Advertisement
Table of Contents
