Table of Contents
Advertisement
AMD NVMe/SATA RAID Quick Start Guide for
Windows Operating Systems
Chapter 3
3.1
Enable RAID for x570/590 AMD Socket AM4/SP3-
Series Compatible Processors
Note: The steps to configure a system to RAID mentioned here are specific to AMD NDA BIOS
based off the AMI BIOS. The steps for other BIOS Vendors are different.
Complete the following pre-installation steps:
1. Power-on the system.
2. Press ESC to enter the System BIOS setup page.
3. In the BIOS setup:
a. Select the Advanced tab.
b. Select CSM Configuration, then press Enter.
c. Set CSM Support to Enabled, then press Enter.
d. Set Boot option filter to UEFI only, then press Enter.
e. Set Storage to UEFI, then press Enter.
4. In the BIOS setup:
a. Select the Advanced tab.
b. Select AMD CBS, then press Enter.
c. Select FCH Common Options, then press Enter.
d. Select SATA Configuration Options, then press Enter.
e. Set SATA Enable to Enabled, then press Enter.
f. Set SATA Mode to RAID, then press Enter.
5. In the BIOS setup:
a. Select the Advanced tab.
b. Select AMD CBS, then press Enter.
c. Select X570/590 Chipset Common Options, then press Enter.
d. Select X570/590 Chipset SATA Configuration Options, then press Enter.
e. Set X570/590 Chipset SATA0 Enable to Enabled, then press Enter.
f. Set X570/590 Chipset SATA1 Enable to Enabled, then press Enter.
g. Set X570/590 Chipset SATA Mode to RAID, then press Enter.
6. In the BIOS setup:
a. Select the Advanced tab.
b. Select AMD PBS tab, then press Enter.
c. Set the NVMe RAID Mode to Enabled, then press Enter.
7. Save (F4) the settings and restart the system.
10
Pre-Installation Steps
Pre-Installation Steps
56268 Rev. 1.05 November 2021
Chapter 3
Advertisement
Table of Contents
