Enable Raid For Amd Socket Am4-Compatible Processors - AMD NVMe/SATA RAID Quick Start Manual

[Public]
56268 Rev. 1.05 November 2021
3.4
Note: The steps to configure a system to RAID mentioned here are specific to AMD NDA BIOS
based off the Insyde BIOS. The steps for other BIOS Vendors are different.
1. Press ESC to enter the System BIOS setup page.
2. Select Setup Utility, then press Enter.
3. In the BIOS setup:
a. Select the Advanced tab.
b. Select IDE Configuration, then press Enter.
c. Set SATA Configure As to RAID, then press Enter.
d. Set Force RAID Mode to Enabled, then press Enter.
4. In the BIOS setup:
a. Select the Boot tab.
b. Set Boot Type to Dual or UEFI Boot Type, then press Enter.
c. Set EFI Device First to Enable, then press Enter.
5. In the BIOS setup:
a. Select the AMD-PBS tab.
b. Set NVMe RAID Mode to Enabled, then press Enter.
6. In the BIOS setup:
a. Select the AMD-CBS tab.
b. Select SATA Configuration Options, then press Enter.
c. Set SATA Controller to Enabled, then press Enter.
d. Set SATA Mode to RAID, then press Enter.
7. In the BIOS setup:
a. Select the AMD-CBS tab.
b. Select Promontory Common Options, then press Enter.
c. Select PT SATA Configuration Options, then press Enter.
d. Set PT SATA Port Enable to Enabled, then press Enter.
e. Set PT SATA Mode to RAID, then press Enter.
8. Save (F10) the settings, then restart the system.
Chapter 3
Enable RAID for AMD Socket AM4-Compatible
Processors
AMD NVMe/SATA RAID Quick Start Guide for
Pre-Installation Steps
Windows Operating Systems
13