Cleaning The Accessories; Oven Racks; Broil Pan - Dacor DISCOVERY EO Use And Care Manual

Installing your oven's filter(s):
• The metal clips on the back of the filter hook over
the metal bar across the fan hole. Place the filter flat
against the back of oven above the hole with the clips
on the back of the filter pointing down. Be careful
not to push the filter too hard against the back wall
because the clips can scratch the surface. Gently push
the filter straight down over the hole until the clips
catch on the metal bar.
Clips on back
of filter
replacing the Convection Filter
Clearing the "Clean Convection Fan Filter"
Message:
note: The "Clean Convection Fan Filter" is a reminder
that you should clean the convection filter(s).
• Following the steps below, you may either choose to
ignore the message and continue baking, or reset the
reminder function. You will have approximately 15
hours of use in this mode before you receive this mes-
sage again.
• When the "Clean Convection Fan Filter" message
appears on the screen, the variable function keys will
be labeled oK, reset uPr, and/ or reset lWr.
• press oK to clear the screen and continue using oven.
Doing so does not clear the warning. Next time the
home screen is displayed, the message will reappear.
pressing oK allows you to leave the message as a
reminder if you are not ready to clean the filter, but
still want to cook.
• If you clean the filter(s) and/or you want to reset
the message and counter, press the variable function
key with the appropriate reset label. reset uPr
will reset the upper or a single oven, reset lWr
will reset the lower oven on units equipped with two
ovens.
Care and Cleaning
Filter
Metal bar
Fan hole on
back of oven wall
31

Cleaning the Accessories

ImPortant: You must remove all accessories from the
oven during the self-clean cycle. If you leave accessories
in the oven during self-cleaning, they will permanently
discolor and/or become permanently damaged. racks will
become difficult to slide.

Oven Racks

• To clean the oven racks, apply a solution of detergent
and hot water. When you need to clean heavy soil, use
a scouring pad such as steel wool with plenty of water.
You may also use a solution of 1 cup of ammonia to 2
gallons of water.
Meat Probe
ImPortant: Do not immerse the meat probe in water.
It will become damaged.
• The meat probe is constructed of vinyl handles, a
wire, a plug, and a stainless steel skewer. To clean
the skewer, use a scouring pad and hot, soapy water.
When you clean the handles, wipe with soft sponge
soaked with a solution of detergent and warm water.
meat Probe

Broil Pan

• Your broil pan has a porcelain enamel finish. When
you clean it, use a solution of detergent and hot
water. If your broil pan is heavily soiled, use a scour-
ing pad with plenty of water. rinse it well after clean-
ing.
Optional Roast/Broil Pan with
V Shaped Rack
• Your roast/broil pan has a porcelain enamel finish.
When you clean it, use a solution of detergent and hot
water. If your roast/broil pan is heavily soiled, use a
scouring pad and plenty of water. rinse it well after
cleaning.
• The optional v shaped rack is finished with an Excali-
bur non-stick coating. When you clean it, use a solu-
®
tion of mild detergent and warm water. use the side of
a sponge to scrub it and dry it with a lint-free cloth.