Dacor Discovery EO127 Installation Instructions Manual
Hide thumbs
Also See for Discovery EO127:
- Use and care manual (40 pages) ,
- Installation instructions manual (20 pages) ,
- Quick start manual (2 pages)
Subscribe to Our Youtube Channel
Related Manuals for Dacor Discovery EO127
Summary of Contents for Dacor Discovery EO127
-
Page 1: Installation Instructions
Installation Instructions Discover y Wall Oven For use with models EO, MO and PO Part No. 65433 Rev. J... - Page 2 All specifications are subject to change without notice. Dacor ® assumes no liability for changes to specifications. © 2007 Dacor, all rights reserved.
-
Page 3: Table Of Contents
WARNING ating this or any other appliance. • Always contact the Dacor Customer Service Team Hazards or unsafe practices that COULD result in severe about problems and conditions that you don’t under- personal injury or death. -
Page 4: General Safety Precautions
After use, make sure these surfaces have had to the oven. Dacor is not responsible for service sufficient time to cool before touching them. required to correct a faulty installation. The owner is •... -
Page 5: Customer Service Information
Model Identification If you have questions or problems with installation, contact EO230xxx your Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under warranty call the Dacor Distinctive Service line. Whenever you call, have the model and serial number of the appliance ready. The model and serial number are printed on the product data plate. -
Page 6: Product Specifications
Product Specifications Product Dimensions Product tolerances ±1/16” (±1.6 mm) Model Number EO127 PO127 27” 25 3/8” (686 mm) (644 mm) MOV127 MOH127 27 15/16” 27 3/8” (710 mm) (695 mm) EO130 PO130 30” 28 3/8” (762 mm) (721 mm) MOV130 MOV130 23 3/8”... - Page 7 Product Specifications Top of chassis 1 1/4” (32 mm) Utility cutout Control panel 66” (1676 mm) front Flexible conduit Top of Chassis notch chassis side view Single Wall Oven Dimensions Top of chassis 1 1/4” (32 mm) Utility cutout Control panel 66”...
-
Page 8: Planning The Installation
Planning the Installation Selecting the Location Model Number • Carefully check the location where the oven is to be EO127 installed. The oven should be placed for convenient PO127 25 1/2” 27” 56 1/2” access, but away from drafts that may be caused... - Page 9 Planning the Installation NOtES: • Cutout tolerances: 1/16”, -0 (1.6 mm, -0) • 24” minimum cutout depth • 3/4” support platform must be flush with Recommended Recommended front of cutout. See page 8. electrical electrical location location 1“ (25 mm) Min. 4“...
-
Page 10: Cabinet Cut-Out (Continued)
Planning the Installation Cabinet Cut-Out (continued) Support Platform WARNING The top surface of the support platform must be installed flush with the cutout in the front of the cabinet or wall and any trim. Failure to install the platform properly may cause the exhaust vent to deform and/or become obstructed. -
Page 11: Electrical Specifications
(2) different sizes may be included. ensure a proper installation before proceeding. If replace- • Standard oven racks two (2) for a single oven, five (5) ments parts are required, contact your Dacor dealer. for a double oven • GlideRack™ oven rack, one (1) •... -
Page 12: Electrical Service Installation
Improper connection of the electrical wiring can Connecting to a Four Wire Electrical cause an electric shock hazard and damage the appliance. Dacor is not responsible for damages System resulting from improper installation. Separate the wires coming out of the appliance conduit. - Page 13 Installation Instructions Connecting to a Three Wire Electrical Connecting to a Three Wire Electrical System - Where Local Codes Permit System with External Ground - Where Local Codes Permit WARNING WARNING Do not connect the green appliance conduit wire to the neutral (white) junction box wire unless local building •...
-
Page 14: Final Installation
Installation Instructions Connecting to a Three Wire Electrical System with External Ground - Where Local Codes Permit (continued) Separate No 10 Min. Cable from circuit copper grounding wire breaker panel or fuse box Junction box WHITE WHITE Clamp must be GREEN BLACK tight on pipe... - Page 15 Installation Instructions Raise the door so that it is at a 15° angle from the front Support the oven at all times until it is secured into the of the oven. Hold the door with one hand on each side. cabinet.
-
Page 16: Verify Proper Operation
See page 3 for location. To avoid damage to the door or personal injury from it Dacor is not responsible for the cost of correcting problems falling off its hinges: caused by a faulty installation. -
Page 17: Installation Checklist
Problems have been noted on the warranty card or dur- □ ing the on-line activation. Warranty has been activated Oven is wired to all applicable codes and Dacor specifi- on-line or the warranty card has been filled out com- cations. See pages 9 and 10. -
Page 18: Notes
Notes... - Page 20 Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.Dacor.com...
Need help?
Do you have a question about the Discovery EO127 and is the answer not in the manual?
Questions and answers