Sd Card Function - Mitsubishi Electric ecodan ECOSLIM150L-PP-MEUK Installation Manual

SD Card Function

26
SD Card
FTC4 is equipped with an SD memory card interface. Using
an SD memory card can simplify main controller settings and
can store operating logs (2Gb will store up to 30 days
operation data).*
1. Use an SD memory card that complies with
the SD standards.
2. SD memory cards to the SD standards include
SD, SDHC, miniSD, micro SD, and microSDHC
memory cards. The capacities are available up
to 32 GB. Ensure the chosen SD card maximum
allowable temperature of 55ºC.
3. When the SD memory card is a miniSD, miniSDHC, microSD, or micro SDHC memory card,
use an SD memory card converter adapter.
4. Before writing to the SD memory card, release the write-protect switch.
5. Before inserting or ejecting an SD memory card, make sure to power off the system. If an SD memory
card is inserted or ejected with the system powered on, the stored data could be corrupted or the SD
memory card be damaged.
6. The read and write operations have been verified using the following SD memory cards, however, these
operations are not always guaranteed as the specifications of these SD memory cards could change.
7. How To Check Read And Write Operations
a) Check for correct wiring of power supply to the system. (Do not power on the system at this point.)
b) Insert an SD memory card.
c) Power on the system.
d) The LED4 lamp lights if the read and write operations are successfully completed. If the LED4
lamp continues blinking or does not light, the SD memory card cannot be read or written to by
the FTC4 controller.
8. Make sure to follow the instruction and the requirement of the SD memory card's manufacturer.
9. Format the SD memory card if determined unreadable in step (6). This could make it readable.
Download an SD card formatter from the following site. SD Association homepage:
https://www.sdcard.org/home/
10. FTC4 supports FAT file system but not NTFS file system.
11. Mitsubishi Electric is not liable for any damages, in whole or in part, including failure of writing to an SD
memory card, and corruption and loss of the saved data, or the like. Back up saved data as necessary.
12. Do not touch any electronic parts on the FTC4 control board when inserting or ejecting an SD memory
card, or else the control board could fail.
Please contact Mitsubishi Electric Pre Sales Technical on 01707 278666 for further information
*1. To edit main controller settings or to check operating data, an Ecodan
*2. An SD memory card is live for a while after the system is powered off. Before insertion or ejection wait until the LED lamps on the
FTC4 control board are all off.
*3. Mitsubishi Electric is not liable for any damages, in whole or in part, including failure of writing to an SD memory card, and corruption
and loss of the saved data, or the like. Back up saved data as necessary.
1
service tool (for use with PC) is required.
®
Pre-Plumbed Slimline Cylinder Installation Manual
65