Mitsubishi Electric ecodan ECOSLIM150L-PP-MEUK Installation Manual page 41

Electrical Installation
23
1. Removing the front cover
Once the front and back covers are separated the back cover can be positioned and holes for the cable and
securing of the back cover/switch box can be drilled
2. Connecting cable to the back cover
Connect the main controller cable to the terminal block on the back cover and thread the cable from behind the back
cover to the FTC4 circuit board. Seal the gap between the cable and the hole through which the cable is threaded.
(continued)
Pre-Plumbed Slimline Cylinder Installation Manual
41