Resetting The Device - Multitech Conduit AP Hardware Manual

SPECIFICATIONS AND HARDWARE INFORMATION

Resetting the Device

You need:
A pin, paperclip, or similar thin object that can fit into the reset hole
To reset the device:
1. Find the hole labeled RESET. The reset button is recessed into the case.
2. Use the pin to press and release the RESET button as follows:
Reset options:
Note: The device reboots when restoring settings.
For more information about commissioning mode, consult the mPower Software Guide or mlinux developer resources.
Refer to Documentation Overview
12
To reboot, press RESET for less than 3 seconds.
To reboot and restore user-defined defaults (if previously set), press RESET for 3 to 29
seconds.
To reboot, restore factory settings, and erase user-defined defaults, press RESET for 30
seconds or longer.
The device restarts in commissioning mode. The system automatically removes all user
accounts.
Enter a new username and password to create your new administrative account. (Refer to
User Accounts in the appropriate software guide for details on username and password
requirements.)
for details.
®
Conduit AP MTCAP2-868 and MTCAP2-L4E1-868 Hardware Guide