Resetting The Device - Multitech Conduit AP User Manual

SPECIFICATIONS AND HARDWARE INFORMATION

Resetting the Device

You need:
A pin, paperclip, or similar thin object that can fit into the reset hole
To reset the device:
1. Find the hole labeled RESET. The reset button is recessed into the case.
2. Use the pin to press and release the RESET button as follows:
Reset options:
Note: The device reboots when restoring settings.
10
To reboot, press RESET for less than 3 seconds.
To reboot and restore user-defined defaults (if previously set), press RESET for 3 to 29
seconds.
To reboot, restore factory settings, and erase user-defined defaults, press RESET for 30
seconds or longer.
The device restarts in commissioning mode. The system automatically removes all user
accounts.
Enter a new username and password to create your new administrative account. (Refer to
User Accounts in the appropriate software guide for details on username and password
requirements.)
®
Conduit AP MTCAP2-LSP3-915x-042-POE and MTCAP2-915x-042-POE User Guide