Installing The Brake System - Marzocchi Bomber Owner's Manual

Installation

3.2 Installing the Brake System

Installing the brake system is a delicate and
critical operation that must be carried out by
specialized personnel.
WARNING!
Brake system
specialized
experience. General mechanical aptitude
may not be sufficient to properly install your
brake system. Please have your brake
system installed only by an authorized
Marzocchi Service Center.
Table 4 - Brake system settings
Fork
Marathon
MX
3
128
D-Street 24"
All Mountain
66
Z1
Dirt Jumper
888
Junior T
Monster
A
V-Brake system
removable setting
Picture 3 - Braking system settings
installation
knowledge, tools
Max disk dimension and fastening system
XC INTL STD 8"
(Installation of 8" disk is only possible when the specific
adapter is supplied by the brake system manufacturer)
(Installation of 8" disk is only possible when the specific
adapter is supplied by the brake system manufacturer)
XC INTL STD 6"
(Installation of 8" disk is only possible when the specific
adapter is supplied by the brake system manufacturer)
B
Brake disk system sheath
Marathon
MX
D- Street 24"
Improper installation of a disk brake system
can overstress the caliper mountings, which
may cause the caliper mountings to break,
resulting in loss of control of the bicycle, an
accident, personal injury, or death.
Be sure that the brake system installation is
also performed in strict compliance with the
requires
instructions provided by the brake system
and
manufacturer.
Use only brake systems that comply with the
forks specifications, taking into consideration the
contents of the summarizing tables contained in
this manual..
Post Mount 6"
Post Mount 6"
Post Mount 8"
supports setting
V-Brake setting
Removable setting
No
C
Brake disk system sheath
supports setting
All Mountain
66
Z1
Dirt Jumper
888
Junior T
D- Street 24"