Handlebar Clamp Installation For The 888 Series - Marzocchi Bomber Owner's Manual

Installation
3.6.2 Handlebar Clamp Installation For
The 888 Series
To install the handlebar clamp, please carefully
follow the instructions below:
• Place the lower mounting segment of the
handlebar clamp on the upper crown of the
fork (see 10A & 10B of Picture 10).
• Align the corresponding holes from each of
these components.
• Secure the lower mounting segment of the
handlebar clamp to the upper crown of the
fork by tightening the screws to the required
torque (6±1 Nm) using a 4mm Allen key (see
10C of Picture 10).
• Place the handlebar into the lower mounting
segment of the handlebar clamp, being sure
that it is centered (see 10D of Picture 10).
3
• Place each upper segment of the handlebar
134
clamp over the handlebar (see 10E of Picture
10).
• Align the holes of the upper segment with the
corresponding holes of the lower mounting
segment.
• Secure the handlebar in place by tightening
each screw to the required torque (6±1 Nm)
using a 4mm Allen key (see 10F of Picture
10).
For installation of handlebars having different
diameters, "reduction sleeves" may be placed
around the handlebar (between the handlebar
and each segment of the handlebar clamp) to
ensure the handlebar is held in place (see 10G
of Picture 10).
WARNING!
When the fender is assembled on a 888 fork,
the position of the superior part of the crown
must be in corrispondence to max line on
the stanchion.
4 mm
6±1 Nm
10C
4 mm
10F
6±1 Nm
10E
Picture 10 - Handlebar Clamp Installation For The 888
Series
10A
10B
10G
10D