Wheel Installation On 66 And 888 Series Forks - Marzocchi Bomber Owner's Manual

3.4.3 Wheel Installation On 66 And 888
Series Forks
For optimum fork performance please follow the
instructions below when installing the wheel:
• Place the wheel in between each fork.
• Align the center of the wheel with each wheel
axle clamp (see 6A of Picture 6).
• Insert the axle through the wheel axle clamp
of the right fork, through the wheel, and then
through the wheel axle clamp of the left fork
(see 6A of Picture 6).
• Tighten the axle to the required torque (15±1
Nm) using a 6mm Allen key to the caps of the
axle (see 6B of Picture 6).
• Check for the proper fork-wheel alignment. To
do this, begin by fully compressing the fork a
few times. The wheel should not make
contact with, or come close to any portion of
the fork. Then lift the front of the bicycle and
spin the wheel a few times to verify the correct
alignment with the disk brake. The wheel
should not wobble from side to side or up and
down. Check the owner's manual of the brake
system for the proper specifications.
• Tighten the screws positioned on each wheel
axle clamp to the required torque (6±1 Nm),
with a "1-2-1" sequence, using a 4mm Allen
key (see 6C of Picture 6).
Picture 6 - Wheel Installation on 66 end 888 series
forks
Installation
6A
3
6 mm
131
15±1 Nm
6B
4 mm
6±1 Nm
6C