Huawei S1700 Series Manual page 208

S1700 Managed Series Ethernet Switches
Product Description
Attribute
Working mode
Baud rate
ETH management port
You can connect a switch to a configuration terminal or network management
workstation through the ETH management port to configure the switch locally or
remotely.
can log in to the switch that contains the ETH management port for the first time
through the ETH management port. For details, see "First Login to a Switch" in
the
for the first time by pressing and holding the MODE button for 6 seconds or
longer and saved the configuration, the default configuration on the ETH
management port will be cleared. In this case, you cannot log in to the switch for
the first time through the ETH management port. You are advised to log in to the
switch for the first time through the ETH management port.
Table 5-80 Attributes of an ETH management port
Attribute
Connector type
Standards
compliance
Working mode
Maximum
transmission
distance
USB port
The USB port can have a USB flash drive connected to upgrade the switch, or
transfer configuration files or other files. The USB port can only connect to a USB
flash drive that complies with USB 2.0.
Issue 18 (2020-10-23)
Description
Duplex Universal Asynchronous Receiver/Transmitter (UART)
9600 bit/s, 19200 bit/s, 38400 bit/s, 57600 bit/s, or 115200
bit/s
Default value: 9600 bit/s
Table 5-80 describes the attributes of an ETH management port. You
Configuration Guide - Basic Configuration . If you have logged in to the switch
Description
RJ45
IEEE802.3
10/100 Mbit/s auto-sensing
100 m
NO TE
USB flash drives from different vendors differ in model compatibility and drivers. If a USB
flash drive cannot be used, try to replace it with another one from a mainstream vendor.
Switches support a maximum of 128 GB USB flash drives.
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Structure
174