Huawei S1700 Series Manual page 164

S1700 Managed Series Ethernet Switches
Product Description
remotely.
can log in to the switch that contains the ETH management port for the first time
through the ETH management port. For details, see "First Login to a Switch" in
the
for the first time by pressing and holding the MODE button for 6 seconds or
longer and saved the configuration, the default configuration on the ETH
management port will be cleared. In this case, you cannot log in to the switch for
the first time through the ETH management port. You are advised to log in to the
switch for the first time through the ETH management port.
Table 5-42 Attributes of an ETH management port
Attribute
Connector type
Standards
compliance
Working mode
Maximum
transmission
distance
USB port
The USB port can have a USB flash drive connected to upgrade the switch, or
transfer configuration files or other files. The USB port can only connect to a USB
flash drive that complies with USB 2.0.
Indicators
The S1730S-S24T4S-A has similar indicators to those of the S1730S-S24P4S-A
except that the S1730S-S24T4S-A does not have a PoE mode indicator. For details,
see Indicators.
Power Supply Configuration
The S1730S-S24T4S-A has a built-in AC power module and does not support
pluggable power modules.
Heat Dissipation
The S1730S-S24T4S-A has no fans and uses natural heat dissipation.
Issue 18 (2020-10-23)
Table 5-42 describes the attributes of an ETH management port. You
Configuration Guide - Basic Configuration . If you have logged in to the switch
Description
RJ45
IEEE802.3
10/100 Mbit/s auto-sensing
100 m
NO TE
USB flash drives from different vendors differ in model compatibility and drivers. If a USB
flash drive cannot be used, try to replace it with another one from a mainstream vendor.
Switches support a maximum of 128 GB USB flash drives.
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Structure
130