Huawei S1700 Series Manual page 152

S1700 Managed Series Ethernet Switches
Product Description
1
3
5
7
Issue 18 (2020-10-23)
Mode switching button
NOTE
Press this button to change the mode
of service port indicators:
When you press this button once, the
service port indicators change to the
speed mode and show the speed of
each service port.
When you press this button again, the
service port indicators restore to the
default mode and show the connection
status of each service port.
If you do not press this button within
45 seconds, the service port indicators
restore to the default mode. In this
case, the SPED indicator is off.
Reset button
NOTICE
To restore the factory settings of a
switch, hold down the Reset button for
at least 6 seconds. This operation will
not reset the switch.
To reset a switch, press the Reset
button.
Resetting the switch will cause service
interruption. Exercise caution when you
press the Reset button.
Ground screw
NOTE
The ground cable is not delivered with
the switch.
AC power socket
NOTE
It is used with an AC power cable.
Copyright © Huawei Technologies Co., Ltd.
2 Sixteen 10GE SFP+ ports
Applicable modules and cables:
● GE optical module
● GE-CWDM optical module
● GE-DWDM optical module
● GE copper module (100M/
1000M auto-sensing)
● 10GE SFP+ optical module
● 10GE-CWDM optical module
● 10GE-DWDM optical module
● 1 m, 3 m, 5 m, and 10 m SFP+
high-speed copper cables
● 3 m and 10 m SFP+ AOC cables
4 ETH management port
6 Jack reserved for AC power cable
locking strap
NOTE
The AC power cable locking strap is not
delivered with the switch.
- -
5 Hardware Structure
118