RGBlink FLEXpro 8 Quick Start Manual page 14

After one of the device is chosen, the device on the topology diagram shows the SN and IP address of the
chosen one.
4. Choose board type of In and Out according to the actual input and output modules configuration user want.
For example, set the first input board as DVI module as the following
Select IN|OUT: In, Model:Universal, Signal:DVI, Port:any figure from 1 to 4, click ADD to finish
If the input module is formed by different signal input ports, choose the Model as Typical, it will allow users to
set port type one by one.
.
© Xiamen RGBlink Science & Technology Co., Ltd.
13 / 46
Ph: +86 592 5771197 | support@rgblink.com | www.rgblink.com