Panasonic AJ-SD93P/E Service Manual page 70

5. Start up the Hyper Terminal of Windows 95/98 on the personal computer.
(Programs of Windows → Accessories → Hyper Terminal → Hypertrm.exe)
Name the Hyper Terminal "1394", and select an icon.
Select the connection method. (Connecting using: Direct to COM*)
Perform settings of the Port. (Bits per second: 9600, Data bits: 8, Parity: None, Stop bits: 1,
Flow control: None)
File → Properties → Settings → ASCII Setup → put a mark on the "Append line feeds to incoming line
ends"
of ASCII Receiving.
6. Turn "ON" the VTR power.
7. Input "uid" and then press the "Enter" key so that the current UID will be appeared.
The 8 digits of the first half are always 0084582.
The 8 digits of the last half are unique code.
8. Input "uid_write:enable" and press the "Enter" key, and make sure that the display shows "&OK".
9. Input "uid********" and press the "Enter" key, and make sure that the display shows "&OK".
10. Input "uid_write:disenable" and press the "Enter" key, and make sure that the display shows "&OK".
11. Input "uid" and press the "Enter" key, and make sure that the UID has been written.
12. Close the software "Hyper Terminal". Turn "OFF" the power of the VTR.
INF-57