Table of Contents
Advertisement
3. Connection
1.
Connect the Flash Memory Version Up Tool (VFK1304A) with Personal Computer (MS-DOS,
Windows 95® or 98®) by RS-232C cross cable as shown in figure 12-2A-1.
2.
Connect the flexible cable from the Flash Memory Version Up Tool to the connector on the board to be
version upgraded as shown in table 12-1 and figure 12-2A-1.
3.
Turn on the VTR power and Personal Computer power.
4.
Copy the Program Data software as shown table 12-1.
Install the version up software VFK1248N into the personal computer.
5.
12-2-2. Microcomputer Flash ROM Version Upgrade Procedure (1)
< SYS-IF Microcomputers (DPROC Board)>
1. Turn on the VTR power.
2. Copy the program software for the SERVO and SYS_IF as shown in the table 12-1 into the personal
computer.
3. Execute the VSI2312N. exe so that the following screen appears.
4. Select the CPU (Microcomputer) sheet as shown in figure 12-2B-1.
Select CPU
5. Select the each item on the Setup Panel as shown in the table 12-2B-2.
Board Name
(Slot No.)
DPROC Board (F2)
(5)
Setting for PC
* The numbers (1) – (5) in the above tables show the number in figure 9-1B-1 (Setup Panel).
(1)
(2)
(3)
(4)
(5)
(1)
Microcomputer
Select
M32182F8(1M)
Port
Stop Bits
Parity
Figure 12-2B-1
(2)
Software
Select
Do not set any one.
COM1
1Bit
Table 12-2B-2
INF-22
(3)
Writing data
FILE
FILE
data
Extension
MOT
.mot or s
Baud Rate
115200
Byte size
8Bits
(4)
Target
machine
ID check
off
Advertisement
Chapters
Table of Contents
