Software Version Display; Software And Pld Version Are Displayed On The Video Super Out (Monitor Tv) And Front Display - Panasonic AJ-SD93P/E Service Manual

7. SOFTWARE VERSION DISPLAY

7-1. SOFTWARE and PLD VERSION are displayed on the VIDEO SUPER
OUT (Monitor TV) and FRONT DISPLAY.
7-1-A. Michrocomputer Software Version on Front Display
1. Turn on the VTR power.
2. Place the unit in the EJECT mode and then press the "PLAY" and "STOP" buttons together so that the
Software Version of the SYSTEM CONTROL (SY) is displayed on the Front Display.
3. Press the "PLAY" and "STOP" buttons again, then the the version display is changed to the Software
Version of the Servo (SV).
Software Version of SYSTEM CONTROL
Software Version of SERVO
4. Press the PLAY, STOP and REW buttons together, then the Check Sum is displyed as shown the above.
7-1-B. Michrocomputer Software Version Display
1. Turn on the power of the VTR and place it in the EJECT mode..
2. Press the "PLAY" + "STOP" buttons and "FP" + "MENU" buttons simultaneously so that the monitor TV
shows the HOUR METER display.
3. Press the Search button so that the Software Version of the Microcomputer is displayed as shown below.
DIAG-MENU
Ser F4TRA0001 - P
* SYS
SRV
END
Software Version
4. Move the cursor (*) by using the Joy Stick (↑↓) so that the display on the Front Panel is changed as
shown the above.
PLAY + STOP BOTTONS
SYSTEM CONTROL
PLAY + STOP BOTTONS
MONITOR TV
SOFT VERSION
p1.02-01-1.00
p1.02-02-1.00
PLAY + STOP BOTTANS
SERVO
PLAY + STOP + REW BOTTONS
PLAY + STOP + REW BOTTONS
9F5C
2ACE
Check Sum
INF-11
FRONT DISPLAY
JOY STICK (↓↑)