Panasonic AJ-SD93P/E Service Manual page 40

12-2-4. PLD (FPG) Version Upgrade Procedure
1. Turn on the VTR power.
2. Copy the program software for the AVMON, AVPROC, DVPROC, D-IF, AVIO and SDI as shown in
the table 12-1 into the personal computer.
3. Execute the VSI2312N. exe so that the following screen appears.
4. Select the PLD (SD93/255) sheet as shown in figure 12-2D-1.
Select PLD (SD93/225)
(2)
5. Select the each item on the Setup Panel as shown table 9-1D-2.
Board Name (Slot No.)
AVMON Board (F2)
DPROC Board (F3)
AVIO Board (F4)
SDI Board (F5)
(4) Setting for PC
* The numbers (1) – (4) in the above tables show the number in figure 9-1D-1 (Setup Panel).
6. Click "OK" button so that the following screen appears and check sum is calculated.
7. Click "Start" button so that the software programming will start.
8. Confirm the bar in the Process window reach to 100% that means the software programming complete
as shown in figure 9-1D-4.
(1)
(3)
(4)
Name of PLD
(Ref. No.)
AVMON FPG [IC3200]
AVPROC FPG [IC1201, 901]
DVPROC FPG [IC1501]
D-I/F FPG [IC10501]
AVIO FPG [IC3400]
SDI FPG [IC255]
Port
Stop Bits
Parity
Figure 12-2D-1
(1)
AVMON
AVPROC
DVPROC
D-I/F
AVIO
SDI
COM1
1Bit
None
Table 12-2D-2
INF-27
Software (3) Writing data
Select
ttf
Baud Rate 115200
Byte size 8Bits