Table of Contents
Advertisement
Tank Filling and Water Treatment
A.
Remove the Rubber Tank Plug from the top of the tank. Insert the Water
Filling Funnel(7) into the tank. Place a large bucket of water next to the
rower and position the Hand Press Siphon(6) with the rigid hose in the
bucket and the flexible hose into the funnel as shown.
Where water quality is known to be poor, we recommend the use
Note:
of distilled water or the water pill.
B.
Begin filling tank by squeezing siphon. Use the Level Gauge Decal (L1-L6)
on side of tank to measure volume of water in tank. The resistance is higher
as more water is inside the tank, so start with a fill level of L1- L2.
If you prefer, you can use a large water cup to fill up the tank
Note:
instead of the Hand Press Siphon.
IMPORTANT
C.
Ensure that tank plug is replaced once filling and water treatment
procedures are complete.
WARNING
other than those supplied with your rower.
: Do not overfill tank!
: Do not, under an circumstances use any treatment tablets
Maintenance and Tips
33
Advertisement
Table of Contents
