Download Print this page
Extreme Tools RX722501HC Manual
Hide thumbs Also See for RX722501HC:

Advertisement

Quick Links

72 inch Steel Top Hutch
shown on RX722519RC
Model: RX722501HC
Extreme Tools, Inc.
740 Frontenac Rd
Naperville, Illinois 60563
630.369.9303
www.ExtremeTools.net
RX722501HC
Parts List
1
2
2
2
2
4
4

Advertisement

loading
Need help?

Need help?

Do you have a question about the RX722501HC and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Extreme Tools RX722501HC

  • Page 1 RX722501HC Parts List 72 inch Steel Top Hutch shown on RX722519RC Model: RX722501HC Extreme Tools, Inc. 740 Frontenac Rd Naperville, Illinois 60563 630.369.9303 www.ExtremeTools.net...
  • Page 2 Step 1: Attach Slide Splicer Posts to Side Panels Step 2: Install Side Panels on Roller Cabinet a. Slide Splicer Post Assembly (#9) into bottom opening of the a. Remove plastic end caps from the top of the trim located at the left-hand Side Panel Assembly(#2).
  • Page 3 Step 3: Secure Side Panels Step 4: Install Back Panel a. Install one Hold-Down Bracket (#14) on each side a. Pull MDF board/Stainless Steel Top forward approximately 1/8” using one flat washer (#16) and one M8 bolt (#15) from Back Raised Edge (aka: Fence Rail.) for each side.
  • Page 4 Step 5: Secure Back Panel & Set Shelf Height Step 6: Install Adjustable Shelf a. Line up the holes on the left-hand Back Panel Flange with the a. Locate the (2) open slots on each side of the shelf. Line up the threaded inserts of the Side Panel.
  • Page 5 Step 7: Attach Gas Struts to Lid Step 8: Install the Lid onto the body of the Hutch a. Lay the lid down on packaging material so that the front of the lid LID is HEAVY! is face down. Be sure to use packaging material under the lid so that it does not get scratched or damaged.
  • Page 6 Step 9: Secure Gas Strut to Side of Hutch Step 8: Secure Lid to Body of Hutch a. Prop open the lid so that it cannot fall. a. Use the Allen wrench (supplied with the parts) to drive the pre- threaded M5-16mm Sock Head Screw (#4) into the round b.
  • Page 7 Use Phillips screwdriver, (4) M4x10mm Machine Screws (#21) and (4) M4 LockNuts (#20) to secure power strip. FULLY ASSEMBLED EXTREME TOOLS RX SERIES HUTCH shown on RX SERIES ROLLER CABINET Step 11: Install Rubber Grommets a.