Alarm Levels - Teledyne Gasurveyor 700 User Manual

Gasurveyor 700
USER MANUAL

3.3.6 Alarm Levels

After the Soundness Test is successfully completed, the monitor will report the alarm set-points for
each range (e.g. LEL range shown in
Figure 17: Warm-up - Alarm set-points (LEL)
CAUTION: It is the responsibility of the user to ensure that the alarm set-
points are appropriate for the safe operation and legal requirements of
the country / industry in which the instrument is being used.
Note: Alarm set-points are configured during the monitor procurement.
3.3.7 Sensors Zero Check
At the end of warm-up, each sensor is zeroed, as shown in
A successful zero check results in a 'tick' symbol against all the monitor's sensors (as shown in
Figure 19: Warm-up - Successful sensor
20
Figure 16: Soundness Test Fail
Figure 17: Warm-up - Alarm set-points
Figure 18: Warm-up - Sensor check
check).
(LEL)).
Figure 18: Warm-up - Sensor check.
49391
Revision 3