Gasurveyor 700
USER MANUAL
3. Operation
3.1. Operating Procedure
Check the following before use:
• The monitor is clean and in good condition.
• The inlet filter is clean and in good condition.
• The sample line and any other accessories to be used are in good condition.
• The batteries are in good condition, charged and fitted correctly.
• The battery indication provides sufficient capacity for the application.
• The monitor is within your calibration period.
• The soundness test is successful.
• All applicable ranges are operational.
• There are no fault indications.
3.2. Quick Configuration Display
This feature allows configuration information to be viewed without fully switching the monitor ON
(see
Figure 7: Quick Configuration
With the monitor OFF, press B2 for one second. The monitor will display:
• Flammable gas calibration.
• List of sensors fitted.
• Due dates (service, calibration, bump).
• Is GPS enabled.
3.3. Switching the Monitor ON / Warm-up Sequence
WARNING: ALWAYS SWITCH THE MONITOR ON IN FRESH AIR.
Press and hold B1 for one second to switch the monitor ON (refer to
instrument logo appears (as shown in
routine.
16
Display).
Figure 7: Quick Configuration Display
Figure 8: Splash
Figure 5:
Screen) and the monitor begins its warm-up
Soft-Keys). The
49391
Revision 3