ECG TK 2080 DR Instruction Manual page 8

Display and controls
1. Display
The first time you switch it on (or after a long power disconnection), all segments and symbols of the
display are displayed for 6 seconds, and then the display enters normal mode. The ambient temperature
is displayed in the range of -9 to 37 °C, the set temperature is in the range of 5 to 37 °C or 41 to 99 °F. The
temperature can be set between 5 °C and 37 °C with a tolerance of ± 1 °C.
Switch button
2.
When you connect the appliance to the power supply and turn on both switches, the display shows the
current temperature of the room and the current set temperature. Wait about 6 seconds and then you can
freely change any values on the display using the buttons, see below.
The button to switch the temperature scale °C/°F
3.
Pressing this button repeatedly switches the temperature display between the Celsius and Fahrenheit
scale.
4. Operating mode button
Press this button repeatedly to switch between power modes:
750W > 1250W > 2000W > tempering (the display shows a star) > 750W > etc...
Fan button (Turbo)
5.
Press the button repeatedly to turn the fan on or off. When the fan mode is active, the fan indicator is lit up.
Button +
6.
Press the + temperature setting button to increase the temperature between 5 - 37 °C (750 W / 1250 W /
2000 W modes only). In the tempering mode the temperature is set firmly to 5 °C and cannot be changed.
7. Button -
By pressing the button - temperature setting you can lower the temperature, the minimum value is 5 °C
(only in 750 W / 1250 W / 2000 W modes).
8. Timer button
The appliance is equipped with a timer, which allows you to set the desired time of heating in the range 1
to 24 hours. After this time period expires, the appliance automatically shuts off. Press the timer button
repeatedly, until the required time period appears (e.g. 1h 00m). If you want to deactivate the timer, press
the timer button repeatedly until the time indicator disappears from the display.
Note: You can set only whole hours with the timer, the countdown displays hours and minutes. To set the
timer, you must first set the temperature and power and let the connector run.
The timer starts after about 5 seconds.
Operation modes and functions of the appliance
1. Modes 750W, 1250W, 2000W:
The heating power is set to 750 W, 1250 W or 2000 W. The display shows the appropriate icon (750W, 1250W
or 2000W). Heating switches on when the ambient temperature drops 1 °C under the set temperature and
switches off once the set ambient temperature is reached.
2. Tempering mode
When you select this mode a star symbol lights up. If the ambient temperature is below 5 °C, the 2000
W heater is switched on and the "2000 W" icon lights up. When the ambient temperature reaches 9°C,
the heaters will switch off, the power icons will turn off and only the tempering mode icon and ambient
temperature information will remain lit.
Fan:
3.
You can turn on/off the fan in the 750W, 1250W and 2000W modes. The fan cannot be used in tempering
mode.
4. Audio signals:
You can hear an audio signal every time you press a button, confirming the press of the button.
Temperature sensor:
5.
The heating is equipped with thermal fuse. When overheating occurs, the control unit shuts off the heating
elements and the symbol "- -" appears on the display of ambient temperature. After normal operation
resumes, the appliance returns to its original operating mode.
Turning off the convector:
6.
8