ECG TK 2080 DR Instruction Manual page 7

The surfaces marked in this way become hot during use.
Risk of burns!
DO NOT COVER! Danger of fire.
DANGER for children: Children may not play with the
Installation requirements
Place the radiator on a flat surface that provides sufficient free space
for proper venting. There must be a distance of at least 1 m between
the device and surrounding objects. The heater must not be operated
without the bases fitted.
CONVECTOR ASSEMBLY
Prior to any manipulation with the device always disconnect the power supply to prevent injury by
electric shock.
Make sure the package contains all parts necessary for assembling the convector. Contact your vendor if this is
not the case. Package contents:
• Convector 1 pc
• Stand 2 pcs
• Fixing screws for pedestals 4 pcs
• Operating manual 1 pc
The base must be attached to the convector before first use.
1. Turn the convector upside down.
2. Fit the two bases on the underside of the convector so that the
holes in the bases line up with the holes in the convector body.
3. Attach using the included screws.
4. Once assembled, turn the convector back to its normal working
position and you can start using it.
OPERATING INSTRUCTIONS
Inserting battery in the remote control:
1. Remove the cover of the battery compartment on the back of the remote control.
2. Insert in the holder in the cover the battery CR2032 (included), pay attention to proper polarity of the
battery.
3. Insert the cover with the battery back in the remote control.
Note: When first switched on or switched on after a long period of inactivity, the heaters may emit odor or
smoke. This is normal and it will fade away in a short while.
After plugging it to the outlet, turn on the heating first with the main switch 0/I and then with the switch on
the control panel or the remote control.
You cannot change the setting or the temperature without switching on both switches.
Do not immerse in water!
packaging material. Do not let children play
with the plastic bags. Risk of suffocation.
7