ECG TK 2080 DR Instruction Manual page 5

convector (1 m) may be higher than usual while it is in operation.
Place the convector to ensure sufficient air circulation.
9. Do not place the convector on a high pile carpet.
10. Do not place the convector in front of or directly under an electric
socket.
11. Do not cover the heat convector! In case of covering it there is a risk
of overheating and fire.
12. The convector must not be connected to the electrical outlet via a
timer or connected to a remote switching power circuit, as in the
case of remote switching on of the covered or incorrectly placed
convector there is a risk of fire.
13. Do not use the convector close to a bathtub, shower or a pool and
do not place in locations where is a danger of it falling into a bathtub
or another container with water!
14. If the device emits an abnormal smell or smoke, immediately unplug
it and have it checked by a service centre.
15. Do not switch off the device by pulling on the power cord. Always
turn off the main switch of the convector first!
16. Always disconnect the power supply before handling, carrying or
maintaining the device.
17. Do not leave a convector with inserted power cord unsupervised.
Disconnect the cord from the electrical outlet prior to any
maintenance. Do not unplug the device by pulling the power cord.
Unplug the power cord from the outlet by grasping the plug.
18. Do not allow the power cord to touch hot surfaces or run the cord
over sharp edges.
19. Do not use the convector in places where flammable materials
are stored (paint, gasoline, solvent etc.) or where there is a risk of
flammable fumes appearing.
20. Do not put your fingers or other objects into the openings of the
heat convector.
21. Do not cover the output openings with a towel, for example, or
when drying any laundry.
5