8.1.10 Accessories - Christ Alpha 3-4 LSCbasic Operating Manual

Freeze-dryer Alpha 3-4 LSCbasic
8 Maintenance and service
→ Pos : 219 /200 Chris t/361 GT-BA Labor-Pil ot ( PROJ EKTE)/Alpha/Al pha 1- 4_2-4_3-4 Standard/Alpha 3-4 LSCbasic/080 Wartung und Instandhaltung/080-0010-0130 Z ubehör Al pha 3-4 LSCbasic @ 60\mod_1540542535823_68.docx @ 602236 @ 3 @ 1

8.1.10 Accessories

CAUTION
Pos : 220 /010 Univ ers almodul e/ Seitenwechs el @ 0\mod_1202116244312_0.docx @ 105 @ @ 1
96 / 117
For the care of the accessories, special safety measures must be
considered as these are measures that will ensure operational safety at
the same time.
Chemical reactions as well as stress-corrosion (combination of oscillating
pressure and chemical reaction) can affect or destroy the metal and plastic
parts. Barely detectable cracks on the surface can expand and weaken the
material without any visible signs.
•
Check the material regularly (at least once a month) for
– cracks
– visible damage of the surface
– pressure marks
– signs of corrosion
– other changes.
•
Replace any damaged components immediately for your own safety.
•
Immediately rinse off the accessories if any liquids that may cause
corrosion come into contact with them.
•
Clean the accessories outside the freeze-dryer once a week or
preferably after each use.
•
Use only the accessories that have been specified by Martin Christ
Gefriertrocknungsanlagen GmbH.
Version 11/2018, Rev. 1.9 of 01/12/2021 • sb
Translation of the original operating manuel