Samlexpower Evolution Series Quick Start Manual page 9

EVO INVERTER/CHARGER |
10. Switch on the EVO
the EVO Owner's Manual
TM
• Press and hold the ON/OFF Button.
• Green LED labeled "ON" will flash 3 times, will go off momentarily, then resume ON
steady. Now release the ON/OFF Button (This procedure takes around 2 sec).
• If the EVO does not start immediately, switch OFF the DC and AC power.
• Investigate the cause of the malfunction by referring to "Fault Messages and
Troubleshooting Guide" in Table 7.1 of Section 7 of the EVO-RC Owner's Manual.
i
INFO
The optional EVO-RC Remote Control provides the user with the ability to modify the EVO
Charger's operating parameters. The default settings in EVO
installations but may have to be modified for others. It is strongly recommended that the user review the
EVO Owner's Manual/ EVO-RC Remote Control Manual before putting any load or charging batteries.
TM
11. Your EVO inverter Charger is delivered with various default configurations
TM
The default values will depend on the model you have. Refer to Section 6.4.1 starting
at Pages 113 through 117 for a listing of programmable parameters and factory default
values. The Remote Control EVO-RC can be used to change these values.
12. The following parameters are the very basic parameters which may require
modification depending on your configuration:
• Date and time
• Charging Voltages (Absorption, Equalization, Float)
• Charging current
• Power Saving Function
!
CAUTION!
If you are not sure of what parameters you need to change or what values to change to, consult your
point of purchase or call Samlex Tech Support. You should also consult a Certified Electrician who is
familiar with Local and National Electrical Codes to ensure a safe and code compliant installation.
Inverter Charger. Refer to Section 6 starting at page 109 of
TM
Quick Start Guide
Inverter Charger are adequate for some
TM
TM Inverter
SAMLEX AMERICA INC. | 9