Mounting The Units - Samlexpower Evolution Series Quick Start Manual

EVO INVERTER/CHARGER |
3. Layout of the EVO
• Refer to Section 2 starting at page 30 of the EVO
with all the relevant connection points and components.

4. Mounting the Units

• Refer to mounting information at Section 3.3 starting at page 34 of the EVO
• Plan a safe location and routing of wiring for the associated components
• Ensure the mounting surface is strong enough to support the weight of at least
60Kg/132lbs
• Ensure that the mounting location is cool, dry and allows unobstructed air flow for cooling
• Mounting requires four (quantity 4) M6 or ¼" bolts to secure the inverter horizontally or
vertically on a wall with at least 8"/200 mm clearance around the unit. All dimensional
information is shown in Fig 3.1 at page 34 of the EVO
!
CAUTION!
PLAN SYSTEM GROUND AND GROUND FAULT PROTECTION PRIOR TO INSTALLATION
• Ensure that the entire installation is properly grounded to meet Local and National Electrical Codes.
• Refer to typical grounding arrangement at Fig 3.12 at page 54 of the EVO
• Ensure that the AC Neutral is bonded to the Earth Ground at only one point.
5. Plan the Battery Bank
• Select the type and size of the battery bank and bank configuration. Refer to Section 3.4
starting at page 36 of the EVO
• Determine the overall Ah capacity (C) of the battery bank.
• Check with the battery manufacturer regarding maximum recommended charging
current. The factory default "Bulk Current" parameter is set to 40A.
• Locate an appropriate area for the battery bank and cable routing to the EVO
• The EVO comes with a battery temperature sensor model EVO-BTS. This sensor
TM
provides battery temperature information to the charging algorithm to ensure a proper
and safe charge to the battery. Refer to Section 2.5 starting at page 33 of the EVO
Owner's Manual.
• An appropriately sized DC disconnect switch is recommended.
6. Select and procure the appropriate wire size and lengths for the intended type of
installation along with the appropriate breaker/fuse sizes
• For sizing the AC input wiring and breakers, refer to TABLE 3.2 at page 50 of the
EVO Owner's Manual.
TM
• For sizing the AC output wiring and breaker, refer to TABLE 3.3 at page 52 of the
EVO Owner's Manual.
TM
• For sizing the DC (Battery side) wiring and fuse, refer to TABLE 3.1 at page 44 of the
EVO Owner's Manual.
TM
TM
Owner's Manual regarding installation of batteries.
TM
Quick Start Guide
Owner's manual to become familiar
TM
Owner's Manual.
TM
Owner's Manual
TM
Owner's Manual.
TM
.
TM
SAMLEX AMERICA INC. | 7
TM