Samlexpower Evolution Series Quick Start Manual page 10

EVO INVERTER/CHARGER |
13. The first parameter you should change is the Date and Time
Refer to Section 4.10 of the EVO-RC Owner's Manual).
To set time and date (no password required):
• Press Enter from any Operating Mode Screen.
SELECT GROUP
• Screen
CHARGE CURVE
Enter Key
SELECT GROUP TIME SETTING
• Screen
TIME SETTING 2000/01/01 00:00
• Cursor will blink on value to be changed.
• Press Up/Down to change value.
• Press Enter momentarily to move to next value.
• When Date and time is correct, press and hold Enter Key for a few seconds to write
your settings.
You are done setting the time and date.
This Quick Start Guide provides basic steps required for planning the installing and operating EVO
Series Inverter Charger. Based on the specific application, actual installation procedure will vary.
Plan your installation accordingly. Please read the entire EVO
Service and Application Engineers are available to assist you with installation, setup, and operating
instructions.
10 | SAMLEX AMERICA INC.
Up Key x 5 Enter Key
SELECT GROUP
will appear. Press Up Key 6 times.
TIME SETTING
will appear. Date and time syntax is YYYY/MM/DD HR:MM
Quick Start Guide
TIME SETTING
2000/01/01 00:00
Owner's Manual. Samlex Customer
TM
TM